Importing the starting point measurement
Every measurement may have different results following the Learning Phase, depending on the flows covered in the original application. Since this is a step-by-step tutorial, it is recommended to start by importing the measurement used for the analysis steps in this tutorial.
Go to the vFunction Server Web UI
Switch to the Analysis page, if prompted then stop the learning
Click MEASUREMENTS (top left pane), select IMPORT MEASUREMENT and then CHOOSE FILE in the popup dialog
In the Open file dialog, select C:\vFunctionLab\measurements\Analysis-Tutorial-Start.zip and click Open
Click IMPORT
The initial measurement should load after a few seconds.
Click on the bell shaped icon at the top of the page to see the notifications - you should have a notification that the learning results include beans and database tables.
Click Configure Parameters under ACTIONS in the left pane:
a. Ensure the checkmark Enable Auto Refactoring is checked (turned on). This will activate the auto refactoring feature of vFunction.
b. Ensure that the checkmark ML Common Detection is unchecked (off).
c. Close dialog (SUBMIT if enabled or CANCEL otherwise)